-
75º Gooseneck punch Configurable in .25" increments from 1" to 101.5" 1", 1.25", 1.5", 1.75", 2", 3", 4", 5", 12", 18", and 24" Lengths Included *Pictures show 53.5" set -
- 90 degree punch and die
- Configurable from 1" up to 53.5" in 0.25" increments
- American style safety tang
- Extra height for bigger box bends
- Meant for use with our B96/150 Press Brake.
-
- User friendly
- Continual system status checks
- Easily viewed message display
- Meets OSHA, UL, ANSI, CSA, RIA, and CE standards
- B48/100
-
- User friendly
- Continual system status checks
- Easily viewed message display
- Meets OSHA, UL, ANSI, CSA, RIA, and CE standards
- B72/100
- B96/150
-
Only works with Conventional Press Brakes- User friendly
- Continual system status checks
- Easily viewed message display
- Meets OSHA, UL, ANSI, CSA, RIA, and CE standards
- Light curtains swings out of the way when not in use.
-
Sliding on two chrome pins, this brake attachment is both heavy-duty and accurate. Fits the SPP40/75 and HP50. Also adaptable to HP100. (Not compatible with the SPP20/50) -
This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 12" Note: The product pictured is the 48" wide model -
This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 18"
-
This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 24" Note: The product pictured is the 48" wide model
-
48" Powered Backgauge for Manual Control.
This backgauge has it's own basic touchscreen control that operates independantly from the press brake control.Simple to use.
Enter the desired position and the backgauge moves to that position under power and remains there until a new position has been entered. May be installed on machines with a Manual Control or CNC Control. Additionally, this backgauge can be easily retrofitted onto older machines if you are looking for an upgrade. -
Upgrade from 1.5 hp to 5 hp (increases calculated speed to: extend 55.8ipm [no load], retract 74.4ipm) -
75º Gooseneck punch Configurable in .25" increments from 1" to 53.5" 1", 1.25", 1.5", 1.75", 2", 3", 4", 5", 12", and 18" Lengths Included
-
- 90 degree punch and die
- Configurable from 1" up to 53.5" in 0.25" increments
- American style safety tang
- Extra height for bigger box bends
- Meant for use with our Press Brakes
-
This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 24" Note: The product pictured is the 48" wide model
