• Caster Kit

    $621.11
    Roll your machine around on these hefty casters
  • Upgrade from 1.5 hp to 5 hp (increases calculated speed to: extend 55.8ipm [no load], retract 74.4ipm)
  • Run the machine while using both hands. Needs a compressed air hookup.
  • This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 12" Note: The product pictured is the 48" wide model
  • 2.36″ (60mm) bolt on die holder with American tang slot. Measurement is front to back width.
  • 3.75" bolt on die holder with American tang slot. Measurement is front to back width.
  • 72 in, 85 deg P112 punch.
  • This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 18"
  • This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 24" Note: The product pictured is the 48" wide model
  • 75º Gooseneck punch Configurable in .25" increments from 1" to 53.5" 1", 1.25", 1.5", 1.75",  2", 3", 4", 5", 12", and 18" Lengths Included
  • This innovative add-on allows you to slide the cylinder side to side on your press. It uses a hydraulic cylinder with a valve control Travel: 24" Note: The product pictured is the 48" wide model
  • 18" press brake with 4-way die.
  • Add pipe and tube bending capability to your ironworker's press station with this complete die set. Whether you're running Schedule 40 pipe or square tubing, this set gives you the dies and rollers to bend it clean and accurate, right at your press.
  • Our biggest press brake option for ironworkers. Not compatible with the SPP20/50
  • 48" of 4W2E 4-way die with die openings .625" @90deg, .875" @85deg, 1.25" @85deg, 2" @85deg.  This die has a 2.36" (60mm) block and is designed for the 2.36" bolt on die holder.
  • 96 in, 85 deg P112 punch.

Title

Go to Top